Are the E2's a must for MAP replacements?

[Ray J Neal]

I am going to have a MAP tank on the way soon once I can locate one from someone in the BST forum. Hopefully I find one soon so I can retire my oversized syringe mods. I have a few CE2 XL's for syringe mods left.
I was about to order some CE2 clearomizers for the MAP and just wiggle the plastic tube off for use in the MAP. But after reading COV description it says that it takes E2 XL's.
So, my long-winded question is will the clear/clearomizer CE2 XL's work? Or only the E2's? It looks like the pictures of the replacements on COV have a bit of material remaining above the threaded bottom end like some was left on after cutting with a pipe cutter or similar tool.

Can I just use the CE2's or are the E2's a must?

BTW, anyone got a MAP to sell? My ProVari want's one really bad

-Ray

 

[hairball]

Clearomizers are a tad bit too small at the base. You need to buy the e2 xl's.

 

[Ray J Neal]

Where can I find some information on where they need to be cut?

 

[mwa102464]

its not really an exact cut size, I cut them about 9/16 or so, as long as it is bigger than the bottom delrin end cap your good to go.! and you need the steel e2's in order to work on the maptank, the clearos are to thin.

 

[5cardstud]

Check the Modders forum.

 

[Engora]

I was planning on getting these from Health cabin:
5pc CE2 Ceramic XL Black Cartomizer(long) for 510(Edition 5) [CE2] - $10.00 : Healthcabin Electronic Cigarettes - Wholesale and Retail--
They are not Clearomizers but CE2 as per their description. Will they fit as MAP replacement?