Aspire Atlantis broken glass concern

[John Alexander]

So I dropped it and the glass broke. It took me about a half-hour to nudge and scrape the glass out, but now I'm concerned that there might be tiny glass fragments that I can't see below the plastic part where the new glass seats. Any thoughts? I tried flushing it out with water, but almost every time it dries I found another small bit of glass stuck in there. I don't want to inhale any glass, of course.

 

[DaddyO]

I'd imagine you could eventually clean all the glass out to your satisfaction. One thing you could consider if you haven't already is picking up the 5ml upgraded tank, it comes with everything needed except drip tip and base that you'd reuse from your existing setup.

 

[Guzz]

Tweezers and dental picks. Get a set and a magnifying glass. Been there, done that.

Fortunately, the chances of inhaling the shards are next to mill. Since the coil head will block any shards that are in the tank from going up the chimney. But as always, keep at it till you get all the pieces out, just to make sure.

 

[John Alexander]

My concern is that I can't see under the plastic part, so there may be some bits of glass under there. Scary.

 

[John Alexander]

Good point. I was worried that glass might get into the juice when I fill it, but maybe I'll use some stuff I don't like (got plenty of that) and then flush it out a couple of times.

>Since the coil head will block any shards that are in the tank from going up the chimney.

 

[John Alexander]

I'd imagine you could eventually clean all the glass out to your satisfaction. One thing you could consider if you haven't already is picking up the 5ml upgraded tank, it comes with everything needed except drip tip and base that you'd reuse from your existing setup.

Thanks. The last part went over my head when I first read it, but that's a good idea, too. If my paranoia continues, I might go that route.