Atomizer low... smok tfv8

Status
Not open for further replies.

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,077
72
Ridgeway, Ohio
Today I got my wismec RX200-S and smok tfv8. Ive been smoking it for past 2 hours and now suddenly after a puff it came up with a message saying atomizer low. Can someone tell me what is wrong with it?
What does the RX200S's display say the measured resistance is?

Do you have another mod to put the Smok TFV8 tank on? Will the tank work on that mod?


I agree with Jdurand that there is a problem (short) with the tank's coil. Try replacing the coil.
 
  • Like
Reactions: Jdurand

Konrad_em

Full Member
Aug 31, 2016
6
5
29
I
What does the RX200S's display say the measured resistance is?

Do you have another mod to put the Smok TFV8 tank on? Will the tank work on that mod?


I agree with Jdurand that there is a problem (short) with the tank's coil. Try replacing the coil.
resistance is equal to 0.00 even if its screwed in.
 
  • Like
Reactions: Jdurand

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,077
72
Ridgeway, Ohio
it even comes up with "atomizer low" when there isnt atomizer screwed in.
resistance is equal to 0.00 even if its screwed in.
Hmmm. Some of the early RX200's had 510 center pin issues if I recall. This is about the only other thing I can come up with.

You didn't answer if you have another mod to put the Smok tank on, or different tank to put on the RX220S.
 
Last edited:
  • Like
Reactions: Jdurand

Konrad_em

Full Member
Aug 31, 2016
6
5
29
Hmmm. Some of the early RX200's had 510 center pin issues if I recall. This is about the only other thing I can come up with.

You didn't answer if you have another mod to put the Smok tank on, or different tank to put on the RX220S.

I think it might be RX200's 510 centre pin issue. I srewed in ijust2 atomizer and its still not working, ill try to put my tank on my friend's mod and we will what happens. Hope it isnt boxes 510 .. how can I fix this if it is 510 centre pin?
 
  • Like
Reactions: Jdurand
Status
Not open for further replies.

Users who are viewing this thread