Hello folks,
I've had this problem recently, the latest incident with a Cisco spec 3ohm HV atomizer. For a little over a day it was working great, and then when I noticed a change I check on my Provari and the ohms read 2.6....shortly after that 2.4 . I've noticed this problem recently with other atomizers of varying resistances. I've read elsewhere of an atomizers resistance changing, but increasing. Does anyone know what could be the cause of this and is there anyway to avoid it? Could I have a bad device that is causing this? I mostly use a Provari, although occasionally a Reo (with 1.5 - 2.5 atties) and a Tekk mod (with the 3-3.5 ones). Any help would be greatly appreciated. Thanks!
I've had this problem recently, the latest incident with a Cisco spec 3ohm HV atomizer. For a little over a day it was working great, and then when I noticed a change I check on my Provari and the ohms read 2.6....shortly after that 2.4 . I've noticed this problem recently with other atomizers of varying resistances. I've read elsewhere of an atomizers resistance changing, but increasing. Does anyone know what could be the cause of this and is there anyway to avoid it? Could I have a bad device that is causing this? I mostly use a Provari, although occasionally a Reo (with 1.5 - 2.5 atties) and a Tekk mod (with the 3-3.5 ones). Any help would be greatly appreciated. Thanks!
