Atties for 6V?

Status
Not open for further replies.

FeistyAlice

ECF Guru
ECF Veteran
Verified Member
Aug 24, 2010
11,566
26,426
Near Dallas Texas
I like the 3.5 510 at 5 volt. I have a couple of native 801s, a Woody and a Woodvil. The 3.5 801 atty, at 6v is just slightly cool for me. I like it better with an 801 at 3 ohm. It does depend on what juice is being used too.

I have HV 306 at 3.5 ohm but haven't used them yet. They may be better at 5v. I have 510s all the way up to 5 ohm but anything much lower than 3.9 ohm 510 is a little hot for me at 6v.

Again, it does make a lot of difference depending on juices. My juices are typically light, sweet, and always over 50% VG; most frequently closer to 100% VG.

Alice
 

Big Hitter

Vaping Master
ECF Veteran
Verified Member
Sep 21, 2010
5,640
10,180
Binghamton, NY
Well the only ones I have tried are IKV 3.5Ω in both 510/306

The 306 aren't worth a crap IMO ... but the 510 version works pretty darn good.
I like it a little better at 5v though.

So I think if there was a good 4Ω atty out there that might be my sweet spot.

Haven't found a carto that can take 6v either. 3Ω boge cartos are great at 5v but not 6v IMO.

Come on Rob, get cranking on the VV REO :)
 
Status
Not open for further replies.

Users who are viewing this thread