Attomizer Fit Issue

[Zaxx]

I have an issue with my Prodigy that just started out of the blue.


I was draggin away, and all of a sudden, no vape. *I tried another atty, and it worked fine. *Put the suspect atty back on, nothing. *Backed the atty half way up the threads, and now get more vapor than before, but the atty is very loose. *If I tighten past one rotation on the threads, the atty won't work.


Is there an easy adjustment for this?

 

[Curtis]

What is the brand/model of the atty, Zaxx? I'm no expert, but this might have something to do with it.

 

[Zaxx]

What is the brand/model of the atty, Zaxx? I'm no expert, but this might have something to do with it.

It's the atty that came with the Prodigy.

 

[BiteMe]

I have an issue with my Prodigy that just started out of the blue.


I was draggin away, and all of a sudden, no vape. *I tried another atty, and it worked fine. *Put the suspect atty back on, nothing. *Backed the atty half way up the threads, and now get more vapor than before, but the atty is very loose. *If I tighten past one rotation on the threads, the atty won't work.


Is there an easy adjustment for this?

I think that you can find an answer to your question on this thread...

http://www.e-cigarette-forum.com/forum/puresmoker/22843-prodigy-v1-troubleshooting-guide.html

Others have had similar problems, and Steve has addressed them here.

Hope this helps!

Chris

 

[Gibby]

I have an issue with my Prodigy that just started out of the blue.


I was draggin away, and all of a sudden, no vape. *I tried another atty, and it worked fine. *Put the suspect atty back on, nothing. *Backed the atty half way up the threads, and now get more vapor than before, but the atty is very loose. *If I tighten past one rotation on the threads, the atty won't work.


Is there an easy adjustment for this?

Yeah, probably going to have to adjust your post to make it further in. Most have had issues with the post not being out far enough, you seem to have the opposite.

Do youself a favor though, don't over tighten your atty!

edited for this.

You can find the instructions on the troubleshooting post

 

[Zaxx]

I tried the suggested fix, but couldn't get the post to protrude any further.

Instead of whacking the hell out of the connector, I'll just use anohter atty.

Thanks for the input.