Available Now - Complete Mod Battery Solutions - Panasonic Hybrid IMR High Drain, Efest IMR & High Drain, LiPo Safe Charging Bags - Flat, Button and P

[yiddleboge6]

Hmmmmmm...............maybe the reason for changing the button was too make room for the twist electronics? Just thinking out loud

 

[zippersnapper]

If I could design it, I would:
1. Keep the original Head button
2. Have the "Twist" on the bottom, just like current.
3. Have the twist knob simular to the bottom cap like a Lava Tube. Nice, but not to thick, easy to grab.
4. Have large, clear & contrasting voltage markings.


I would like a SS , so it has threads like that of the Provari, but the cost would skyrocket, I'm sure...

I'm thinking the Buck circut is in the bottom of the current eGo twist, and not in the button location, but this is just a guess on my part..I dont know for sure...

 

[Briar]

Hmmmm... If that happens, I might get it. Just for the tubes. OMG, like I need something else... Well, it's not here yet, i'm safe for now...

 

[yiddleboge6]

Efest IMR 18650 2000mah 3.7v Rechargeable LiMn batteries • Efest IMR High Discharge Performance 3100

Much acclaimed battery for your mod with many comparing it favorably to the more expensive AW counterparts and at a much more reasonable cost. You can be sure that GotVapes has purchased these from one of the top, if not the most respected battery wholesaler.

Safe chemistry LiMN means reduced risk of venting with flame or explosion. Due to the safety inherent in IMR safe chemistry batteries there is no protection circuitry added or built in. This provides a slightly shorter battery length to enable a good fit in most mods.

To ensure longevity, it is not recommended to allow the battery to discharge below 2.5v.

Please note that due to their inherent safety, IMR cells don't have a protection circuit built in. They should never be discharged below 2.5 volts or cycle life/performance will be reduced. Maximum charge voltage is 4.25 volts.

We have both IMR and Protected Efest in stock.

========================================================================

Panasonic IMR Hybrid High Drain 18650 Li-Ion

The Powerful IMR High Drain HYBRID CGR18650CH 3.7V 2250mAh Battery made by Panasonic, manufactured in Japan.

This is made for high current applications (up to 10A), more than enough to run most high drain devices.

This high capacity battery (2250mah) provides much longer run time than a standard IMR battery.

A great choice for vapers needing a high drain battery for their vaping applications.

•Always exercise caution when charging any Li-Ion device, do not leave unattended and it is recommended to keep an eye on your charging location at all times. Use of a Safe Battery Charging bag is recommended.
•Info on this Panasonic battery tech: Panasonic has developed a new Solid Solution technology by mixing the high capacity characteristics of the Li-ion chemistry [cobalt based] cells, and high safety of the LiMn2O4 [manganese based] Lithium based batteries.

Other Important Safety & Usage Notes:
•Do not discharge below 2.5 volts as this will shorten the life of your battery.
•Use only high quality battery chargers
•Use common sense, do not expose to heat or leave in the sun. Use a battery charger that will cut off at 4.2v - Do not charge battery over 4.21 volts
•Do not charge unattended
•Do not store batteries fully charged for extended periods of time.
•Store in a cool and dry place.

======================================================================

Batteries & Chargers : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more​

 

[Adrena]

Yeahhhhhhhh I can now get backup batts for my tox