Batteries For Mech Mod & Low Ohm Atties

Status
Not open for further replies.

PhreakySTS9

Ultra Member
ECF Veteran
Verified Member
Jan 26, 2011
1,130
617
Shayol Ghul, The Great Blight
You don't want the AW IMR. AW's are great for VV/VW devices, but to get the most out of a mechanical mod with a super low ohm coil, you want the MNKE 18650's!

These: https://www.rtdvapor.com/online-store/batteries/mnke18650-detail

They're out of stock there, I was just posting it so you could get a peek at them. I'm sure you can find them elsewhere, I actually need to get some, now that I'm learned in the most up to date mech/low ohm RBA news! Not only do they put out more power than AW IMR's (and WAYYY more power than your battery you're using) they are safer as well for super low ohm stuff. I honestly probably wouldn't use that battery for a mech/SLR setup because I doubt it has the specs to keep up safely, but I may be wrong, as I don't know anything about those batts and somebody else could likely answer it better.
 
Last edited:

c00lkatz

Senior Member
ECF Veteran
Verified Member
Dec 10, 2011
171
83
Dallas, TX
Definitely ditch the Samsung for this application. I've been using AW IMR 1600mAh for SLR because that's what I have on hand, and performance is great. But I will definitely get MNKE when time comes to replace these.

Oh and definitely do not stack two 3.7v batteries in a mech mod.

Sent from my LG G2x via Tapatalk 2
 
Status
Not open for further replies.

Users who are viewing this thread