Bellus Spitback

[Nuker34]

Hi,
I just got the Bellus and I've had leaking problems, but the wicking sorted it out and now the new problem is that I'm getting loads of spitback.
If I have more than 0.5 ml of e-liquid in the tank I'm getting spitback instantly.
I have a lot of wick, but my best guess is that the problem is in the pg/vg ratio of the liquid that I'm using. I'm using 50/50 and it might be wicking too fast.

Any suggestions?

P.S.
I'm using it on the iStick 60w and vaping on about 45w on a dual coil build (0.3ohm).

 

[ppeeble]

Run mine at 25w (0.35 ohms) with no spitting issues. I use 70% VG.
It's probably the liquid viscosity.
Mine leaks a drop or two every time i fill it but i put that down to the laws of physics...

 

[Nuker34]

Run mine at 25w (0.35 ohms) with no spitting issues. I use 70% VG.
It's probably the liquid viscosity.
Mine leaks a drop or two every time i fill it but i put that down to the laws of physics...

Yea I thought so...
Btw you run it on only 25w??
Thanks for the feedback

 

[ppeeble]

Yeh, tried 30w and got the occasional dry hit when i was chain vaping. It's always a compromise between too much and not enough, hard to get it just right. Still one of the best atties i've got though.