best atty for 5v?
- Thread starter breakdown00
- Start date
- th_trl_thread_readers 0
-
- Tags
- altsmoke
- Status
this really depends on what you might like. 510 will give a very warm vape.
901 probably more flavor and 801 cooler vape but bigger cart.
you can always get a 510 and use adapters to any cinfig you like and any atty. Thats what I do. Works good.
901 probably more flavor and 801 cooler vape but bigger cart.
you can always get a 510 and use adapters to any cinfig you like and any atty. Thats what I do. Works good.
I would have to say the 510 is a very durable atty IMO....That being said, I haven't owned anything else other than the M401. I can say I've been using the same atty for 2 months with no maintenance what so ever and it's still doing great!
I used 510's for my 5V PT almost a month now with no problem. 5V is too hot for M401's ,i would constantly get the dried metal taste.
Nick
Nick
I have a 5v mod for a 801 atty but I bought an 801 to 510 adaptor and a 801 to 901 adaptor. After using all 3 attys at 5v I found that the 801 performs the best (just my opinion) but the 510 isnt bad either. The 901 is ok but I prefer it at 3.7 much more. The main trick at 5v or 6v is to make sure your atty is super wet and once you start to barely taste the hot burnt taste drip more or top off your cart. I was dripping 3 drops on my 801 at 3.7v and it was fine but I found that for the best taste and enjoyment on either my 5v or 6v mods that I need to drip 5 drops. I thought this would flood the atty but I haven't had any problems for over a month of high voltage vaping. Hope this helps
He has set these up as High Voltage Atomizers...he's done this by raising the resistance of the coiled element within the Atomizer....Esentually you're supplying 5v's to the Atomizer but only getting the performance of 3.7v....seems like a waste of voltage to me
In General(Damn i'm probly going to screw up these numbers, i dont have my multimeter on me...so these numbers we will call Random)
a 510 is about 2-2.5ohm
a 901 is 2.5-3ohms
801 3-3.5ohms
at 5v's
510 = 10-12.5 Watts(VERY WARM, LOTS OF VAPOR, Kind slightly burnt taste)
901 = 10-8.4 watts (Warmish, Good vapor, Good taste)
801 = 8.4-7.14 watts(Colder, less vapor, Great Taste)
Last edited:
I just have a question ... someone could email me the answer vwilsonwildrose@aol.com. I have a Vapor King. I want to know if there is an atomizer and refillable carts that will adapt to this product??? All this product has is pre-filled cartomizers. I love them but I would like to switch off when I run out of carts.
In my experience, they all perform satisfactory at 5volts. The biggest factor of separation among the three is longevity. It seems to me that the 801 lasts the longest when using at 5v. The 901 would follow and finally the 510. Most mods run somewhere around 1 amp when delivering 5 to 6 volts. While a USB pass through will deliver 5v at only a half amp, unless it has an inline battery, then it only runs at 3.7v.
Where did you find your adaptors
~Jim Mitchell
3 pack a day smoker, Smoking for over 40 years.
That is until 12:15 pm Oct. 14, 2009 when I totally switched to vaping!
Zero analogs since that time.
They don't have one for the 4081 atty, which is super on the copper mod. I'm sure it would be awesome on the silver bullet
- Status
Similar threads
- Locked
