best setup for an Ithaka dual coil?

[Dean Pachano]

I just got an ithaka clone that is setup dual coil at 1.6 ohms. My evic is not getting a good draw and after some reading I am now understanding that I need a different setup for this configuration.

What is a good battery/mod to run this kind of setup? Something that is a starter (don't want to spend over $100 at least for now).

 

[Oomee]

Battery AW IMR 18650
mod .... MBK TS (can ditch the 510 connector and use the TS instead) .
*note if your clone supprts the TS connector , that is*
I use the 2 Ohm premade no res/res wires .

 

[SissySpike]

I use dual 30 gauge micro coils with eco wool in my Ithaka.. Works like a champ very consistent dependable atty. I take it to work all the time. Im not sure how the clone compares

 

[Dean Pachano]

Thanks for the tip! Today I'm going to see if I can find a MBK TS locally and if not I will order from Stormys

Battery AW IMR 18650
Mod .... MBK TS (can ditch the 510 connector and use the TS instead) .
*note if your clone supprts the TS connector , that is*
I use the 2 Ohm premade no res/res wires .

 

[crxess]

Simpler, cheaper, good working solution
Ready Wire for Coils- Longer Length

Get the 1.8ohm 2" coils

Run 1 Coiled wick X(crossing) one uncoiled wick.
eVic will run without issues.

You can also wrap 2 wicks with the 1 coil and split to channels.