Well,....I guess it's about time I finished one of the Triangular mods.....
A little history, first.....
Initially, it was to look like this.....
The thing I just couldn't get past was this....
The button, being centered, sat right in front of a magnet. Even with the button shrunk down from 7/16" to 3/8", it was right up against the atty.
And that's with a 22mm atty....making it impossible to run a 24mm atty, at all...
Once the decision was made to increase the bottle size to 10ml, It moved the atty a little farther away, but still not enough for a 24mm atty, and that's with a 3/8" button, which in my humble opinion is too small...
I decided, at that point, that the button didn't belong in the center. It just wasn't right for this mod.
After much consideration, I decided to move it over to the left. Like this...
Now that the button is in this location,... a location that no one else is using,... It just seems right. To me, at least...
When holding the mod with the flat side, the "back" of the mod, against the palm of your right hand, it seems natural that the button be where it is. When I hold it this way, my ring finger reaches around just perfectly to hit the squonk hole. It also works really well for a thumb squonk, without having to adjust your grip.
So what you have is a parallel, dual 18650 squonker, that accepts the 10ml Cappy V4 silicone bottle, Made from 7068 aluminum, with solid silver positive and negative contacts, that uses the conductive metal body as an integral part of the circuit.
I will use the same bridge that I use for the inline dual 18650 (CCII), that has the solid silver strip, connecting the battery +'s. This way, you'll have a single, silver to silver, make/break point, on the top side of the bridge, and not at the battery itself. And, of course, you'll have the solid silver negatives in the bottom of the battery holes.
It's gonna be awesome.
