Wonder if peng is beating distorto yet?[emoji38][emoji38]
Hmmmmm that calculates to 34..... We definitely need a family photo![]()
Sent from my LG-H815 using Tapatalk
Wonder if peng is beating distorto yet?[emoji38][emoji38]
Hmmmmm that calculates to 34..... We definitely need a family photo![]()
Wonder if peng is beating distorto yet?
Sent from my LG-H815 using Tapatalk
2 coils, long-wise so they lay in the channel, tilted so the edge closer to the outside are pointing slightly downward and the edge towards the center are upward. Don't do single wick through both coils. Each coil gets its own wick.
You either need to build really low, or build high (ohms). 0.4 and below or 1.0 and higher. I personally, found the atty heated up a bit much for low builds, so I went for the 1.0-1.2 range. It works very well for me. 26gauge.
The many ways you can build on it, vertical, horizontal, stove-top, 8 coil, etc.... are daunting. The one I mention was someone else's suggestion and it works great for me.
Thanks, Peng!
I'ma try the low build first and see what's what. Hopefully it won't get too hot.![]()
Dual tilted it is, then!
I was a bit worried that the wick might block the airflow, but the tilted coils should work nicely.![]()
So Corey will finally join the trifecta club?
When buying in bulk it's less, think it was $65 for a pack of 4
Consider what you spend on an atty or some drip tips, we got spoiled because BF started out with 59 cent bottles, then someone went and put a high end stainless steel cap on a 59 cent bottle and yeah it was better but this... Whole other league

Penguiness' explanation was very good, but a pichur sure helps! Thanks!
Another one drugged by the hype
Not buyin it![]()





These kids today, eh Bob?
With their newfangled whatchamadoosits......
![]()
Quinella?Perfect!
Thanks for the picher, buddy.
Sadly, no...
I'll only have a dosfecta... Aluminum and Ti.
![]()

Wonder if peng is beating distorto yet?
Sent from my LG-H815 using Tapatalk


That's 1.One cannot judge the value of a product by the cost of the materials that went into making it.