Big issues with Burnt flavour.

Status
Not open for further replies.

HR15

Full Member
Verified Member
Apr 12, 2012
25
0
38
Brisbane Australia
Hey all,
I've got the ego-t 1000mAH with the LR and normal R atomisers type A and type B. Im using a 50/50 vg/pg mix 11mg juice. Im getting this chronic burnt taste with them after about a day of vaping and no amount of cleaning with iso propal or boiling helps! What am i doing wrong? I can really see myself giving up the darts with these e-cigs but this harsh and burnt flavor im getting is making it hard to keep with it.
Please help!
TIA

HR15
 

BadMoonRising

Full Member
Apr 24, 2012
31
27
VA
I switched over to clearomizers since I was getting a faint plastic taste from the tanks on my inferno but I did figure out a couple things along the way.

Make sure you are priming your atomizers with a few drops after cleaning and let them sit with the tanks in for about 10 minutes. Then do the 5-10 draws without power.

Make sure you never run low on juice in your tank! I never let mine drop below 1/3 full otherwise I would risk going dry or the tanks started to leak.

Are you chain vaping? If I vape too much, which really isnt much at all with the tankomizer set up on my inferno the atomizer was getting too hot and burning the juice. I kept one finger slightly on the cone so I could tell if it was going from warm to hot.

I have one newly cleaned I just finished vaping thru the burnt taste on. Only took a couple minutes and I didn't inhale since it really does taste awful. Now its just fine.

If you get the really burnt taste make sure you clean out the inside with a qtip to remove any burnt juice.

Finally, maybe its time to try something else? There is so much info on here both good and bad I just decided the hell with it and tried everything. tanks, clearomizers different styles. It was definitely a higer up front cost but now I know exactly what I like and what works best for me.

Hope that helps and hopefully some veterans can chime in with some more advice.
 

slojas

Senior Member
ECF Veteran
Verified Member
Feb 21, 2012
189
152
Saskatoon
It's the 50/50 juice, it is so thick that it fails to feed the atomizer properly and allows scorching of the wicking material and terrible burnt vapes.
I killed 4 perfectly good carto's with 50/50 juice not realizing what was happening, 50/50 juice is more for the dripping IMO.

Throw a Boge2.0 LR cartomizer on that Ego and fill'er up with a thinner mix like 70pg/30vg or thin the existing 50/50 juice with PG or vodka then Vape like crazy adding a couple drops into the carto every once in a while to keep it moist.
 
Status
Not open for further replies.

Users who are viewing this thread