Blinking LED?

[Madcaprym]

I am using my provari v2 with my boge LR carto at 4.3v and once in a while it will shut off and the button will blink?? What does this mean? There is no error message. This happens even with a full battery. I have to unscrew the batt to get it back. Is this a short? i couldnt find this in the manual. like I said there isn't a error message? Thanks
UPDATE:
I believe that it is just my battery at 3.6v. I thought the low battery light would flash at a lower voltage than 3.6? Im using only the recommended AW IMR 18650 2000maH batts!

Anyone with same issue? How about the new Mini?

 

[crackbag]

how long have you owned it?

 

[echos67]

Check the spring in the cap isnt compressed but becareful you dont pull it all the way out I read they can be tough to get back in. Do you have the regular cap and a 18490 to see if it does it then too ?

Mine flash low battery around 3.4 I think, usually change it before it starts flashing though the 18490 will last me all day and into the next.

 

[Madcaprym]

I'm only using the extended cap with 18650. I don't think the spring is the problem? It just does it once in awhile . Won't I get an error message if it's something wrong? I have had my. Provari for two months

 

[echos67]

It sounds like the flash like when a battery is installed, if that's the case it may be a connection problem. Spring, dirty threads, or dirty contact inside, batteries can also contribute, have you checked the voltage when it did this ?

 

[aziffel]

I am using my provari v2 with my boge LR carto at 4.3v and once in a while it will shut off and the button will blink?? What does this mean? There is no error message. This happens even with a full battery. I have to unscrew the batt to get it back. Is this a short? i couldnt find this in the manual. like I said there isn't a error message? Thanks
UPDATE:
I believe that it is just my battery at 3.6v. I thought the low battery light would flash at a lower voltage than 3.6? Im using only the recommended AW IMR 18650 2000maH batts!

Anyone with same issue? How about the new Mini?

It's a low battery indicator,3.6v,no load(atty or carto firing)=~3.3v under load, means dead battery.

 

[Madcaprym]

Yup thanks!

 

[ScottinSoCal]

If you're using a weaker battery, it may not be able to keep up with the power draw you're trying to use. That can trigger the low battery warning prematurely. I've only ever used the AW IMR batteries that ProVape sells, but others have reported problems with different batteries.

 

[Madcaprym]

I only use AW imr 18650 2000mah batts that provape recommends. As I stated above!