Blue Lightning Acrylic Mod Not Firing

[YoureFired]

I don't know if this is the correct forum for this, but I have a question about a Blue Lightning Acrylic mod. It fired for a few minutes when I first got it used from another ECF member. Since then it just registers at 0 volts. The 14500 battery is charged up and registers at 4.1 volts.

I've tried prying up the connector pin, but of course, it registers at 0 volts, so I guess it's not the pin being pushed down too far.

Can I replace the connector on it? Those are just a couple dollars at madvapes, I think? I've searched for how to replace a connector but found nothing that I can understand.

Any related links or advice would be much appreciated. Thank you

 

[Guinnesspubcan]

Have you checked the fire button?

 

[YoureFired]

I wouldn't know how to check the fire button. It looks like the same type of button that was in my Bolt. Does it unscrew or pop out some how? I don't want to break it trying to take it apart. But you make a good point, it could be the button connection and not the 510 connector on top.