boil your cotton wicks

Status
Not open for further replies.

spacenoodle

Senior Member
ECF Veteran
Verified Member
Nov 8, 2013
89
26
Seattle, WA
just rebuilt a protank atomizer. tastes like q tip. i bet boiling will get rid of this. will be buying some cotton balls to boil soon and save my qtips for my ears.

on that note, any rule of thumb for how many loops of the coil equate to how many ohms? don't really feel like buying an ohm meter. BUT, i have a MVP, so using VW should assure consistency anyway right?
 

emus

Vaping Master
ECF Veteran
Jun 9, 2009
4,804
2,007
I'd buy cheapo DMM at least.
you can fire un-wicked coil to test performance; If dry coil glows red in about 1 second it may be a keeper. If coil is slow remove a loop or 2. If coil is faster than 1 second wick burn is more likely.

Doesn't hurt to boil the cotton but you will still get that cotton taste for a while if wick thickness isn't perfect.
 

vaperature

Moved On
ECF Veteran
Oct 8, 2013
1,752
1,869
Chicago
I successfully rebuilt my first protank head yesterday. It works great. Had to do it three times before I got it right. The first one shorted because wires were touching. The second one tasted like burned rubber. I figured out the reason for this being I didn't clip the wires close enough to that tiny rubber grommet that you have to shove in there. The final one works just great. Looking forward to saving money by building my own in the future.
 

emus

Vaping Master
ECF Veteran
Jun 9, 2009
4,804
2,007
I don't feel like answering such a question as to how many "loops" for anyone who does not feel like buying a multimeter. And a lot of people will agree with me.

But with that. Some devices have built in ohm meters.

I agree.
I'm more concerned w/ hard shorts than number of loops.
Some RBAs are known to produce hard shorts out of the box.
Ask my omega clone; I was so excited to try my new RBA I didn't test and a hard short fried the hot spring.
DMM can save you from a hard short accident.
 

EddardinWinter

The Philosopher Who Rides
ECF Veteran
Verified Member
Jun 13, 2012
8,866
28,169
Richmond, Va
No rule of thumb for loops, because loop width varies.

Resistance is per length of wire, normally specified per foot. Divide ohms / foot by 12 for ohms / inch and you can eyeball it.

But wire varies and shorts happen, so you should always check the final resistance before you fire it.

Solid and straightforward. Not even a hint of a straw man.

There may be hope for you yet...
 
Status
Not open for further replies.

Users who are viewing this thread