BoxMod / Advice needed

[jack eidolon]

Hello community,

I would like to buy a Box mod. But I have not the experience yet to decide which one should I try.

What I would like to get is a box capable of fire dual coils, a built in battery, 0.3-0.4 mínimum resistance and not that expensive as a sigelei

So far I like the new MVP 3 version, but i'm pretty sure there are a few more options out there that I haven't found.

I have some experience building RDAs, and I know the Ohm law basics.

Thanks in advance for any response!

 

[dhood]

I just picked up the iStick 50 watt. It would handle your needs for a reasonable price and has a 4400 mah battery. The MPV is 3800 mah, so you'd get a bit more life out of each charge. It will also fire down to .2 ohms.

 

[Serielle Vapist]

For the money you are probably good with the Sigelei, you might look at the Cloupor line (I have a T 6) or the Eleaf I Stick line.

 

[CoilinTrouble]

Sigelei all the way! The 50watt version isnt very expensive...Totally enfatuated with my 150 tho. Since I got the Sigelei 150 every other regulated mod I own gathers dust

 

[v1k1ng1001]

I just got a sigelei 50w v2 and it's pretty amazing. The Sigelei and IPV boxes are the best bang for the buck, but you will need to buy 18650 batteries which might be a deal breaker for you. On the other hand, the istick 50w is more affordable.

 

[CoilinTrouble]

The old addage holds true..."you get what you pay for". Ive heard that the isticks perform well for some time however they do eventually hit a point where problems occur (look in the APV section of the forums to see what I mean). Something like the Sigelei will never have to worry about stripped threads or bad center pin contact (spring loaded center pins are awesome). Not to mention if your mod has an unremovable internal battery the battery will eventually go out and then the entire unit needs to be replaced, whereas something like a Sigelei or IPV uses 18650 batteries which are easily replaceable (12$ for 2 Samsung 25r batteries) that perform just as, if not more admirably, than internal batteries. My 2 cents

 

[Wissel Joe]

I have the Kamry 20 goes to 23 watts and down to .3 ohm works great for me I got it for $37 the copper one is the Kamry

 

[v1k1ng1001]

Keep in mind the OP is in Guatemala so finding batteries might be a challenge.

 

[Ycore]

I'm currently using a SMOK xPro BT50 with a Kangertech Subtank and a .3 ohm coil on the RTA. I absolutely love this mod. Yes, it does take a single 18650 battery but it charges in the mod via USB so no need to keep taking it out to charge my mod. Of course, there is no pass-thru function on it so when it's charging, I'm back to using my old iTazte MVP. But for the price of the BT50, (I think I paid around $80) it is a very solid box mod. And it has bluetooth functionality for an app on my phone to see realtime vape data while I'm using it.

 

[smplx]

maybe some thing w a 50w yihi chip. My opinion is that its always nice to have a replaceable battery. Why not something with a usb charge port so you dont have to pull em out?

 

[newjack21]

I have a smok xpro x36 that I love. I got it free from the store I work at, but they are relatively inexpensive. It does 45w at .2 ohms. Nice and warm, adjustable all the way down, or it can run manual. I was nevera box mod guy, but this thing is cool!