BoxMOD help please

[Matt Heaton]

I can not find any info about this have been looking all night.
I have done work on a lot of small electronics, even did a simple box mod.

I am about to do one with a dna40, so what I am wondering is can I make a custom pcb to connect all the buttons. I know I don't need to do this I want to so I can make it look cleaner. I would connect the dna board and my custom pcb board with small semi- tight wires would look like a corset.

Does anyone see a problem with this, it is going to be powered by dual 18650's

Thanks

EDIT: I would also add the charging USB female to the PCB too.

 

[Matt Heaton]

The thing that i can't figure out is if the amps would be to high for the pcb

 

[drmarble]

The buttons are all low current. Only milliamps flow through them. The pcb should work fine. You just need heavy wires for the battery and the 510 connector.

 

[Matt Heaton]

The buttons are all low current. Only milliamps flow through them. The pcb should work fine. You just need heavy wires for the battery and the 510 connector.

Thanks a lot thats what i was thinking I just didn't want to rig it up then it not work making the pcb is kind of a pain ha
But again thanks didn't think I was going to get an answer on this!