Just opened up my new kanger unitank yesterday and started using it. Today I tried to see if I could put a double coil from my t3d in the unitank to get a warmer hit sine the uni coils are single. Needless to say it threaded up fine but was too long to put the unitank back together so I put the original coil back in and reassembled. Now I did get a small amount of juice in the chimney tube when I did all this so I dried it out with tissue and double checked all my seals, blew through it to get remaining juice out. I had it sitting upright for about a half hour and im still getting juice in the chimney tube. I cleaned it all out again and checked seals once more. Let it sit upside down for half hour too see if juice would come out mouthpiece but nothing. Now im getting a small (but still more than normal) amoumt of leakage to the battery and I keep seeing air bubbles collecting in the tank. My seals should all still be good, considering its brand new and im always very careful with them and thread slowly. Im at work now so cant really get too far into checking it out till I get home but if anyone has any ideas of where I should start when I do look at it at home I would definitely appreciate it
