Brass?

[disturbed1]

I hope this is the right spot for this.

I was just wondering what brass can do to you. I mad a bottom fed box mod about 3 week back. I had a cheep little atty so I drilled put the post (which turned to be brass). Iv been vaping on it exclusively for about 2 weeks not. yesterday I noticed a slight burning/tingling feeling in my hands towards the end of the day. Iv been vaping the same juice for quite some time so I don't think its that.

any impute is welcome.

 

[AaronY]

I would get a stainless steel atty. The atomic clone is stainless steel and easy to modify I hear. Not sure if the lead from brass can affect you that fast. But I hope you feel better.

 

[disturbed1]

I would get a stainless steel atty. The atomic clone is stainless steel and easy to modify I hear. Not sure if the lead from brass can affect you that fast. But I hope you feel better.

Thank you. I have another arty that I cut the insulator on and I'm going to give that a try.

 

[Katmar]

I would stay away from brass. Period. Good luck!!!

 

[Majestic]

I hope this is the right spot for this.

I was just wondering what brass can do to you. I mad a bottom fed box mod about 3 week back. I had a cheep little atty so I drilled put the post (which turned to be brass). Iv been vaping on it exclusively for about 2 weeks not. yesterday I noticed a slight burning/tingling feeling in my hands towards the end of the day. Iv been vaping the same juice for quite some time so I don't think its that.

any impute is welcome.

Since brass is used quite frequently in plumbing fixtures especially water faucets, if your body had a problem with the brass alloy you should have experienced a reaction long before vaping. Personally I would be looking for another cause such as nicotine and try cutting back on frequency or strength. My best guess is that you drilled the atty to improve on the performance of it and are now enjoying it more often or you're getting a good stronger dose of vaper. Hope you find the source and feel better.

 

[disturbed1]

Thank you for the feel better. I drilled the center post to make it a bottom feeder. I have sins started using one the I cut the insater on and have knotest it much less. However the air hole is a bit smaller on this one.

 

[ClintS]

It's not the brass, but the lead that is contained in the brass. And it does not take much lead to create health issues yet it may take years to show up.

The only brass that does not have lead in it are brass alloys with silicon.