Broke my MVP 2?

[Storemyace]

I think I broke my MVP 2 tank! I was refilling it and I think I may of got some of the liquid in the little tiny plastic/rubber hole! Now when I try to take a vape very little vaper comes out! How do I fix this, I'm [edited]

HOW TO FIX THIS ISSUE > http://www.e-cigarette-forum.com/fo...-iclear-30-leaking-clog-fix.html#post12836397

 

[jimbodaddy74]

If you got liquid in the center tube of the tank, you probably just got too much liquid on the wick/coil for it to vale properly. Give it a boost of wattage for a few hits and see if it helps.

 

[K_Tech]

Deep, cleansing breaths!

When you say you "broke your MVP 2 tank" what exactly do you believe you broke? The tank or the MVP 2? What tank are you running on your MVP, what plastic/rubber hole do you mean, what power/voltage are you vaping at, and what is the resistance of the coil in the tank?

 

[Katcandoo]

What kind of tank are you using on the MVP?

 

[Storemyace]

I'm using an iClear 30, there's a little rubber piece in the middle that has a pin size hole, I think liquid is trapped inside!

 

[Storemyace]

Liquid is also leaking from the bottom of the tank into the atty!

 

[Storemyace]

Someone please tell me how to fix it!

 

[db13berry]

Pics please?

 

[Storemyace]

Pics please?

Yes, One second

 

[K_Tech]

I don't own an Iclear30B, but I'll bump your thread...

 

[db13berry]

Also what Ohms is your atty reading?

 

[jimbodaddy74]

You could also blow through it from the bottom a bit. Sounds like you got a fair amount of liquid in it. Just do as your avatar says.

 

[PhatRon]

If it's the top coil iClear 30 then just unscrew it from the MVP, put a piece of paper towel under the 510 pin and blow into it a few times and it should shoot any liquid inside the center tube out the 510 connection. If it is the 30b then tip it upside down and do the same thing. You can also take the juice out of the tank, take off the rubber piece that covers the coils and then do what I advised above. It will do the same thing.

 

[Storemyace]

It's hard to see but there's liquid trapped in that rubber tube thing.

 

[VapieDan]

Make certain it is the atomizer and not the MVP2. I know a flooded tank can cause panic if you have not experienced it before. Try another atomizer or cartomizer on the MVP. If another works you know it is the atomizer. If you have no idea what to do with a flooded tank dump it and rinse. Dry over night. Fill properly.

 

[Storemyace]

Also what Ohms is your atty reading?

When I press the P and U button it says A2.1 is that the Ohms?

 

[Storemyace]

Make certain it is the atomizer and not the MVP2. I know a flooded tank can cause panic if you have not experienced it before. Try another atomizer or cartomizer on the MVP. If another works you know it is the atomizer. If you have no idea what to do with a flooded tank dump it and rinse. Dry over night. Fill properly.

Can I rinse it with water?

 

[jimbodaddy74]

Yes. Use hot water. But just try blowing the excess out first and see if it help your situation.

 

[Storemyace]

I am completely broke until Friday, so I can't afford replacement until then. I need to find a DIY fix.

 

[Storemyace]

Yes. Use hot water. But just try blowing the excess out first and see if it help your situation.

Thank you, I will try this now. Maybe I should invest in a back up MVP for situations like this