broken center pin

[RiRi0093]

@RiRi0093

When you typed 0.03 did you mean that or did you mean 0.3?

My bad, i meant i use 0.3 to 45 ohm in coils and 25 to 45 in wattage . im sorry

 

[RiRi0093]

Okay... are you sure your trapping the leads really well underneath the screws and that everything is really tight and the coil can't be pulled out?

Then, are you making sure your coil glows evenly from the inside out before wicking?

Yes i tighten screws and make sure everything well in tact . and checking the coil to evenly fire before i put in the cotton . btw im using the geekvape ammit mtl rda

 

[Territoo]

Yes i tighten screws and make sure everything well in tact . and checking the coil to evenly fire before i put in the cotton . btw im using the geekvape ammit mtl rda

I didn't mean a prewound coil in an rda. I meant a tank with factory built coils. That way there's no way it is your build that is the error. I'm not saying it is your build, it's probably not. But it's something to check before tossing the mod. It can be a used coil. You are just using it to check if the mod can read it or not.

 

[RiRi0093]

I didn't mean a prewound coil in an rda. I meant a tank with factory built coils. That way there's no way it is your build that is the error. I'm not saying it is your build, it's probably not. But it's something to check before tossing the mod. It can be a used coil. You are just using it to check if the mod can read it or not.

Thanks, im not using factory coils, i think im using the wrong coils as Opinionated stated. i think i ruined my mod

 

[Opinionated]

Thanks, im not using factory coils, i think im using the wrong coils as Opinionated stated. i think i ruined my mod

No... your NOT using the wrong coils.

That isn't the point we are trying to make.

@Territoo is simply asking if you have a tank that came with the Smok kit?

If so... you can use that to see if the atomizer short message is due to the mounting of your own coil on the Ammit, or if it's your Smok mod issue.

It's just another way to check.

I thought it might be an error in the way you were mounting the coil because you stated you were getting reading of .03 (Which is very bad) but you corrected that information and said you simply made a typo... which is fine!

 

[RiRi0093]

No... your not using the wrong coils. This isn't the point we are trying to make.

@Territoo is simply asking if you have a tank that came with the kit?

If so... you can use that to see if the atomizer short message is due to the mounting of your own coil on the Ammit, or if it's you Smok mod issue.

Thanks, i bought the mod tankless . the suggested tanks are sub-ohm

 

[Opinionated]

Thanks, i bought the mod tankless . the suggested tanks are sub-ohm

Okay that's fine...

It's probably just the fact it's a bad mod... Smok has a bad reputation.

 

[UncLeJunkLe]

Check to make sure that the positive pin on the 510 of your RDA is tightened properly.

Other than that, it has to be your mod. It could be the batteries, but I doubt it.

 

[sonicbomb]

Sounds very broken

 

[classwife]

Merged duplicate threads

 

[Izan]