broken mods

[SabinDavarious]

Hay new to the ECF. I have 2 mods completely different but both have done the same thing. I have an m16 and a raijin mec mods I bought at a brick and mortar. I've been using them for about 2 months and now the plastic insulators have melted and popped out of the top cap where my addys connect the insulators are not damaged just have come Unseated any help on how to safely fix these would be appreciated I build rather hot most of the time so I know I can't just use super glue

 

[Necrotic]

If you're talking about the delrin you could easily just superglue them back into place. Happened with my pegasus clone and I just used some superglue (very small amount around the inside of the mod. Placed the delrin in it and held it together with vice grips for about an hour. Works perfect now! Not sure how that might help with yours but this is what I've done to fix it.

 

[jswag5]

fat daddy vapes sells tube blanks that you cut and mold to your desired length and size

 

[SabinDavarious]

I was under the impression that super glue would melt and or fail under the heat from super sub ohm

 

[Necrotic]

I was under the impression that super glue would melt and or fail under the heat from super sub ohm

Used my Pegasus for a long while after I super glued and I would go as low as .25 and never had a problem.

 

[SabinDavarious]

I sub down to .07

 

[k702]

I sub down to .07

Good luck....

 

[Wraith504]

Mixing baking soda with superglue will form a reallllly hard resin.

 

[SabinDavarious]

Ok will try that thx

 

[zherbst]

I was under the impression that super glue would melt and or fail under the heat from super sub ohm

No super glue will not melt with heat because it crystallizes and is resistant to heat.