Hi guys, I’d like some advice if possible.
I have a voopoo drag black resin, the chip died on me so I’ve stripped it out.
My plan is to change the 510 to a bottom feeder, insulate the entire inside with a thin layer of plastic, trim down the battery sled as I want to keep it and use it. Then mill out the front screen and up/down holes so you can press a 20ml squonk bottle.
I’d like to keep it fully mechanical, by running positive and negative copper around the mod, would this work as a parallel configuration or should i use wires and a fet?
Sent from my SM-G955F using Tapatalk
I have a voopoo drag black resin, the chip died on me so I’ve stripped it out.
My plan is to change the 510 to a bottom feeder, insulate the entire inside with a thin layer of plastic, trim down the battery sled as I want to keep it and use it. Then mill out the front screen and up/down holes so you can press a 20ml squonk bottle.
I’d like to keep it fully mechanical, by running positive and negative copper around the mod, would this work as a parallel configuration or should i use wires and a fet?
Sent from my SM-G955F using Tapatalk
