Burn
- Thread starter Speechystream
- Start date
- th_trl_thread_readers 0
- Status
What was the ohm rating on the coil? How many volts did you run it at? If you just cranked up the voltage, it is possible you burnt the coil.
I am using the Baby Beast Quad coils at way below the recommended wattage and I have to agree with you there @r77r7r
The standard MT3 clearo which is the delivery device that comes with the 'kit' uses tiny pieces of silica wick, a 2.4Ω coil & very restrictive airflow.
Best used with 50/50 pg/vg because any higher vg won't wick reliably.
It is important to wet the wicking material with liquid (prime), fill tank, let sit for a few minutes before pushing the fire button.
Also, always start off a new / unused head at a low power setting & gradually work your way up to prevent scorching & burning.
Best used with 50/50 pg/vg because any higher vg won't wick reliably.
It is important to wet the wicking material with liquid (prime), fill tank, let sit for a few minutes before pushing the fire button.
Also, always start off a new / unused head at a low power setting & gradually work your way up to prevent scorching & burning.
Reads as though you got a good deal of good advice. Cannot think of much else, if anything to offer adding.
Hope you do it sorted though. I too have had burnt taste a few times and know it isn't pleasant.
After using two brand new tanks today I went back to my Nautilus Mini and it had a brunt taste because I must have singed the coil! New atomizer and all fixed!
I wish the Baby Beast had coils for use with TC but even in plain wattage mode they work very nicely.
I expect it's a simple case of not letting the silica in the atomizer head soak enough or simply too much power.
Titan in the UK is not the same as Titan sold by the vape co. in Dallas.
It's a VV eGo with an MT3/evod type tank?
Titan in the UK is not the same as Titan sold by the vape co. in Dallas.
It's a VV eGo with an MT3/evod type tank?
- Status
Similar threads
