Burnt Juice

[geekinpynk]

Alright so we have been vaping for about a year now, making our own juices since November. We haven't had much of a problem with juice flavoring or anything like that until just recently. We decided to change or Vg/pg levels knowing that it can reduce the burning of the throat. So my questions are these: Can changing the vg/pg levels make the juice easier to burn and if so is there a way to prevent the burning of the juice? The flavors are just not the same, is there ways to bring out the flavors once you start changing vg/pg levels?

Thanks,
GIP

 

[lulu836]

We need a little more information to give you an accurate answer. What ratios were you using and what ratios have you changed to? What type of juice delivery system are you using? What battery are you using? Are you using cartomizers, carto-tank, tank?

 

[geekinpynk]

Well we changed from a 50/50 blend to a 65 vp / 35 pg. Our flavors were purchased through Mt. Vapor Baker. Our nicotine is at 48 mg and reduced down to either a 18 mg or 15 mg (depending on the smoker) and is purchased through Wizard Labs along with our Vg/Pg. Anything else?

 

[Davenkay]

Try cutting the voltage/wattage until you find a sweet spot. Some of my juices do not vape well over 6 watts.

 

[Dj tank]

Try cutting the voltage/wattage until you find a sweet spot. Some of my juices do not vape well over 6 watts.

+1. There are some citrusy flavors that I vape at 4.5 to 4.9 on a 3ohm cartomizer in a dct tank and they taste awesome. Screw on another tank same specs but filled with blueberry and cream it's burnt tasting unless I dial down to 3.8 to 4.3.

 

[Judge Dredd]

I doubt it's the chemicals causing the burning. That is usually representative of too much power being used.

 

[geekinpynk]

Can it vary from mod to mod?

 

[geekinpynk]

Also on the note of mods what carto would be the best for a box mod with tank. I have an ego twist and upgraded to the box mod. I buy my cartos at a local friend owned shop here in Utah and they offer a standard and low res. I always get the standard for my twist and never had a problem. Should I be using a low res for the box mod?

 

[Echoitali]

I'm new to vaping, I've using a kanger t3 and a twist at 3.8. The taste is very good, unless I chain vape. I received a 1.8 ohm dct in the mail today and filled it with creme brulee'. Primed it and let it soak for 15 minutes. I'm getting a burnt taste no matter what setting I have the twist on. The juice is want 2 vape brand and doesn't state the vg/pg mix. Just wondering why it tastes burnt and what I may be doing wrong.