Can a Tank add a metallic taste to the vape?

Status
Not open for further replies.

Katcandoo

Super Member
ECF Veteran
Verified Member
May 4, 2013
585
1,582
Georgia , USA
Sounds like you didn't get all the machine oil out. Make sure you remove all the screws and get everything scrubbed out well.

Ditto. I had the same taste with my kayfun even after washing it several times. I took it apart and cleaned really well with a q-tip. There was still some nasty black oil in the nooks and crannies. Once that was out the bad taste went away.
 

Portertown

Ultra Member
ECF Veteran
Oct 20, 2013
1,103
1,304
Greenville, NC, USA
When you clean the Kayfun, you need to remove the 510 positive screw from the bottom and clean the inside of it good and clean the hole that it comes out of also. I found a glob of metal shavings and a grease type substance in the air hole of the 510 screw on a new Kayfun clone. This is the area that air enters when you take a vape.
When you put the 510 positive screw back in make sure the positive block that it screws into is centered correctly so it does not short to the negative post. There should be a straight/even gap between the positive block and the negative post after everything is back together.
 

Vulcano

Senior Member
ECF Veteran
Jul 8, 2014
230
46
Mexico
When you clean the Kayfun, you need to remove the 510 positive screw from the bottom and clean the inside of it good and clean the hole that it comes out of also. I found a glob of metal shavings and a grease type substance in the air hole of the 510 screw on a new Kayfun clone. This is the area that air enters when you take a vape.
When you put the 510 positive screw back in make sure the positive block that it screws into is centered correctly so it does not short to the negative post. There should be a straight/even gap between the positive block and the negative post after everything is back together.

Will do it, already washed it with soap and hot water, but will check the air holes tomorrow morning....
 
Status
Not open for further replies.

Users who are viewing this thread