Can anyone help with a couple Vapeonly BCC issues

[Sally_]

I'm having two issues with my Vapeonly BCC, this is silly but I'm having problems with not being able to put the coil together after popping it open to adjust the wicks. I just can't keep a proper grip on it, my fingertips still hurt and that was hours ago. I tried putting it in the base to get a little more stability but it didn't help.

Two, I didn't have this problem originally, but now the draw is off. It's like trying to drink a Frosty from Wendy's through a coffee stirrer. I'm using it on an evic, what can I do to fix that.

 

[nobreak1970]

If you are having a problem with that little post that had to be popped off...screw the coil head on the base....put the base on the battery (make sure the battery is off)...get some pliers and push the post back on very carefully. It'll take a bit of a push but will pop back on.

If this isn't the issue then ignore what I said.

 

[Sally_]

No that's the issue with the coil, I'll give that a try.

 

[Sthur]

I rebuild the vapeonly bcc coils. Hardest part is getting the metal post off. After the rebuild it normally is not bad getting it back together. Push the top on against a hard surface. Try possibly switching over to cotton in stock coils if you have done rebuilds before.

Mine seem to vape fine after rebuilds, no bad air flow on ego or evic. I am using mini bcc not max though.

 

[devauto]

The draw problem might be from adjusting the wicks, perhaps you have somehow blocked the flow a bit in your efforts to adjust them? Just a thought ...

 

[Sally_]

I couldn't get the post out without using pliers, I've never done anything with rebuilds but I could probably thread the cotton through the coil to see how it works out. I don't think the draw issues are from adjusting the wicks, the draw on the tank I have the cinnamon roll in (w/ wick adjustment) is actually slightly better than the one I have vanilla in (No adjustment)

Found a thread that mentioned a 510 to 510 adapter may help with draw issues? Anyone had any luck with that?

 

[Sally_]

Another thought, could modifying the collar of the evic to increase airflow, and what (and how) would be the best way of doing that. That came to mind because the draw on my MT3s can be hit or miss with the collar on, but I hate how it looks without the collar.