Can I use...

Status
Not open for further replies.

carpedebass

Ultra Member
ECF Veteran
Verified Member
Jul 10, 2011
2,168
1,500
56
The Alamo City
Yes you can as long as you don't mind having to replace your batteries faster than normal. The stress the MOSFET switches which will cause certain death faster than if you used regular resistance.


Either way, I think a lot of folks tried the eGos and found they work well with LR type attys performance wise. My situation is similar. I bought the eGo-Ts thinking I would like the less fiddly tanks. Turned out I was wrong. I couldn't stand the tanks, so I tossed them after I tried the EMDCCs. When these batterys fail, I'll likely move to an E Power or similar that will not have the Mosfet switch issue and have higher mAh...this equals fewer charges with the advantage of cheaper battery replacement.
 

DaBatMan

Super Member
ECF Veteran
Sep 21, 2011
551
465
Wayne Manor
I see. I kind of understand. I just want to make sure that I have this right. The first set of caros I purchased for my eGo were Boge 2ohm LR and I loved them. It seems that they are pretty hard to find though and I see lots of 1.5ohm cartos, dual coil ect...

The lower the ohm... the hotter the burn, correct? I must add that I'm using the 1000mah batteries.
 
Last edited:

KeysBum

Ultra Member
ECF Veteran
Verified Member
May 2, 2011
1,660
1,319
Florida Keys, USA
I see. I kinf of understand. I just want to make sure that I have this right. I first set of caros I purchased for my eGo were Boge 2ohm LR and I loved them. It seems that they are pretty hard to find though and I see lots of 1.5ohm cartos, dual coil ect...

The lower the ohm... the hotter the burn, correct? I must add that I'm using the 1000mah batteries.

My two favorite cartos are the boge 2.0 and the smok 1.5 dc,s. Never had a problem. you can get them here
Crystal Clear Vaping
 
Status
Not open for further replies.

Users who are viewing this thread