Can someone post a FYI on how to fix a recessed 510 connection Pin on a lavatube

Status
Not open for further replies.

bacc.vap

Vaping Master
ECF Veteran
Verified Member
May 18, 2011
4,147
2,219
Virtualville
I have'nt had to do it ,but if I did I would screw a carto in, if possible, and gently pull out with a rocking motion, while making sure to not pull the top cap off the tube. If that could'nt be done the top cap would have to be taken off the tube ( very carefully) then push it out from the backside. Can't really be any more specific cause I have't really had to do it.
 

A17kawboy

Senior Member
ECF Veteran
Verified Member
Jul 20, 2012
229
98
Northern BC, Canada
Nay nay nay on the carto pull. There's a youtube vid on it. Can't remember the exact name though. It's just the center part that you want to pull up. Use a very small screwdriver or some such and very gently pry up one side then the other of the center post. It doesn't take a whole lot. Don't pry too hard or you could pop it right out.
 

bacc.vap

Vaping Master
ECF Veteran
Verified Member
May 18, 2011
4,147
2,219
Virtualville
Nay nay nay on the carto pull. There's a youtube vid on it. Can't remember the exact name though. It's just the center part that you want to pull up. Use a very small screwdriver or some such and very gently pry up one side then the other of the center post. It doesn't take a whole lot. Don't pry too hard or you could pop it right out.

You right, somehow I missed the word " pin " in the op. Sorry about that glaus.:facepalm:
 
Status
Not open for further replies.

Users who are viewing this thread