Cartomizer leaking?

Status
Not open for further replies.

charady

Ultra Member
ECF Veteran
Verified Member
Nov 17, 2011
1,279
2,068
Iowa
I have a cartomizer that I have tried refilling. The problem is that when I put more than like 3 drops in, it all runs out the bottom. I am not getting it in the center hole at all and I am filling from the top, dripping on the sides. Am I doing something wrong, or is it time for a new cartomizer?

These are cartomizers that came with a basic 808 battery. They were blank, filled them up and used them. Then I needed to refill it some and it started doing this. Thanks for any help!
 

5vz

Super Member
ECF Veteran
Jan 19, 2011
981
216
in here somewhere USA
How long have you been using it? Perhaps it is just an overfill, I still do that from time to time. Or you got some running down the center? Try to blow a bit out into a napkin, then see if it still leaks. If not, it is just too much juice or down the center.

If it looks all burned and yucky inside, just toss it and try a new one. It may just be finished.
 

charady

Ultra Member
ECF Veteran
Verified Member
Nov 17, 2011
1,279
2,068
Iowa
I haven't let them get completely dry, I try to top them off as it gets a change in flavor, if that makes sense. Hmmm. I don't think I am overfilling, doing it the same way that I did with my first 2 cartomizers from my first kit. I suppose I may have let this one get too dry though, I have a cold at the moment so flavors aren't as strong.

Thanks for the help folks :)
 

donnah

Vaping Master
ECF Veteran
Verified Member
Aug 22, 2010
4,470
4,463
Albemarle, North Carolina
also it depends on how old it is. It may be time to toss it. something I found works very well for refilling smoketeck cartos is to put the condom on the batt connector end when I'm refilling and let it sit a few minutes. The condom stops the juice from going out the bottom and gives it a chance to soak in. If it all runs out when you take the condom off the center tube is probably punctured and you need a new one.
 

Link

Senior Member
ECF Veteran
Verified Member
Oct 16, 2011
112
24
SmokeFreeville usa
I have a cartomizer that I have tried refilling. The problem is that when I put more than like 3 drops in, it all runs out the bottom. I am not getting it in the center hole at all and I am filling from the top, dripping on the sides. Am I doing something wrong, or is it time for a new cartomizer?

These are cartomizers that came with a basic 808 battery. They were blank, filled them up and used them. Then I needed to refill it some and it started doing this. Thanks for any help!

i have noticed this recently also,..i determined it was from the thickness of my juice at the time (sweet-vapes choclate/pb brownie-yumm). what i think happens is the poly-fill gets "gummed" up so even though it tastes like you need to fill...when you try to fill, the poly will not absorb anymore so it leaks out, just as it would if you had filled a new one too much.

i suppose you can boil/clean and re-use.
 

charady

Ultra Member
ECF Veteran
Verified Member
Nov 17, 2011
1,279
2,068
Iowa
i have noticed this recently also,..i determined it was from the thickness of my juice at the time (sweet-vapes choclate/pb brownie-yumm). what i think happens is the poly-fill gets "gummed" up so even though it tastes like you need to fill...when you try to fill, the poly will not absorb anymore so it leaks out, just as it would if you had filled a new one too much.

i suppose you can boil/clean and re-use.

That makes sense, thank you! Hopefully my new kit gets here soon and I can play around more but I have to make this work for now :)
 
Status
Not open for further replies.

Users who are viewing this thread