Cartomizer with Drip Tip?

[ZooKansas]

Hello all, need some advice. Does anyone use a drip-tip with their cartomizers? I have been using Boge 2.0 and 3.0 cartomizers and I generally like them. Sometimes a bit of juice comes out of the rubber mouthpiece, and I'm always careful not to overfill and/or get juice in the center hole. So, will using a drip-tip with them solve this problem?? Much appreciated!

 

[sfkid]

I always use a drip to with my cartomizers. The drip tip stays cool (on the LR) which I like.

As far as getting juice in your mouth, if you dont over fill , the drip tip should help.

Since the driptips have a larger opening then the rubber gasket on the original carts, condensation does not tend to build up in side the cart and the changes of getting any juice in your mouth is greatly reduced.

 

[ZooKansas]

Big thanks sfkid! Any particular drip tip you recommend. Saw a thread recommending Pyrex drip tips, but I suppose for cartomizers any drip tip would do.

 

[Hatecraft]

I always use a drip tip with my cartomizers too. I usually pop the drip tip off when adding juice instead of dripping down the hole as it helps avoid getting juice in the center hole of the cartomizer.

 

[Dougiestyle]

I use the metal drip tips from goodprophets.com. @ $.99, the price is the lowest I've found. Buy a couple different styles to figure out which one is most comfortable to your lips. I use 510 Boge LRs and have never used the rubber mouthpiece, only a driptip.

 

[ZooKansas]

Will be placing an order for some drip-tips today...thanks guys.

 

[bstedh]

I have found that the design of the tips on the new Vortex from gotvapes almost entirely eliminates the juice or condensate in the mouth problem. They have a hollow portion that captures most of it. The tip is a little loose but I really like it. I love the Vortex but as I still have many other cartos I have been using the tip on them also. I have been looking for but hav not found yet a similar tip that will fit snugly. For right now I think I may use a small pipe cuter to dimple the end of the carto to grab the tip firmly. Just have to be real careful not to actually cut through the metal.

 

[Andyhrn]

Or you could use plastic cup from cartomizer.