chain vaping with a mech mod???

[mariotenuta]

Hi all,
Im slowly getting into mech mods and I am paranoid as all hell lol. I am a chain vaper and I am wondering if there are any dangers in this with a mech??
Thank

 

[*deleon517*]

as long as you know your battery safety in terms of what it can and can't do. as well as understanding basic ohm laws in regards to those batteries capabilities, all will be well. I chain vape all day long on a mech with rebuildables around .8-1.0hm. It's all a matter of learning and understanding what your gear is capable of.

 

[Ahoy]

As long as you use the correct batteries that provide the right amperage to power the resistance of the load(tank/rda ect) then you will be fine. Chain vaping is fine, we all do it!

 

[irishfire]

The downfall to mechs over regulated, you need to keep batteries on hand, on mechs you vape the volts left in the battery, regulated, you vape whats set. Dont get me wrong, I LOVE my mechs but you need to change batteries to keep the ape you want, unless you kick it.

 

[vapero]

At first I used to check the batteries every hour because I too was a bit concerned of over discharging (and you should at the begining) in no time youll get the hang of it and know when you should change it

 

[mariotenuta]

Thanks guys. Just a little paranoid I guess.

 

[Vapeaholic]

Better paranoid than careless.

 

[mariotenuta]

I just got a sentinel v4 from grand vap

 

[mariotenuta]

Sorry pressed send by error. So I just got a sentinel v4 by grand Vapors. I built a new coil on my taifun which I was vaping on my provari. It was reading 2.2ohms. The minute the sentinel came in I put on the taifun hit the button and boom I got a burst of heat on my battery and what seemed to be a short. My battery was warm but no real swelling.
I re checked the ohms of the taifun on the provari still read 2.2 I decided to try it on my vtr and no read !!!!
So I decided to continue using my aspire tanks until I know my rebuildables are solid