Changing juices in the DID?

[Commie]

Hi there!
Sorry, this might be a stupid question, but is there a way to change juice in the did clone without rebuilding the whole coil? I can't figure out how to clean/rinse it without pulling the resistance wire off:-(
Also, I assume I shouldn't be too thorough with cleaning the SS wick?

Thank you!

 

[flbutterfly1]

Put a syringe in and suck out old juice. flush with water. Your wick will still be wet though. I take wick and coil out and rinse wick and put same coil/wick back in with new juice.

 

[spraintz]

/\/\ What he said...

I change juices all the time. I just syringe out whats left and the I take some alcohol in a syringe and shoot it into the tank and give some squirts to the coil and wick to dislodge some of the bigger pieces of crud buildup. Shake it all out. maybe let it dry out if yer super picky, I personally don't care. Fill up with new juice and rock-n-roll!!!

whole process for me takes about a minute.

 

[Commie]

/\/\ What he said...

I change juices all the time. I just syringe out whats left and the I take some alcohol in a syringe and shoot it into the tank and give some squirts to the coil and wick to dislodge some of the bigger pieces of crud buildup. Shake it all out. maybe let it dry out if yer super picky, I personally don't care. Fill up with new juice and rock-n-roll!!!

whole process for me takes about a minute.

Thank you! Will try. I assume you don't "dry burn" it after alcohol rinsing?

 

[spraintz]

nah, I just shake it out some and then just throw some new juice in there. Easy peasy. I'm not talkin tons of alcohol either.....just enough to flush out the old juice.