Chocolate mint juice burning (taste) :(

Status
Not open for further replies.

ridethespiral

Super Member
ECF Veteran
Verified Member
Jan 7, 2013
323
111
Edmonton AB, Canada
Just got my chocolate mint in from jughead, cleaned out a brand new kanger T2 (coil head as well). Filled it up, set it to 3.6v (LR Coil), had about 5 vapes and then it started tasting burnt. Took out the head and sure enough there was black around the coil. Cleaned it out with hot water and dry burned and tried it again at a lower voltage. Of course it started burning again, so I cleaned the coil again and did a dry burn. This time I poured ~7mL of the juice into a bottle and added a few drops of water. I made sure to put a bunch of drops directly on the coil and filled up the clearo again and waited 10 min. I started at 3.2v and worked my way back up to 3.6v and after about 15 puffs, it started tasting burnt again.

The juice is 50/50 mix.

I have the french vanilla I just got as well in another brand new LR T2 and it tastes absolutely delectable running at 4.2v. Also a 50/50 mix.


I really want this chocolate mint to work! It tastes so good. What can I do?
 
Last edited:

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
It's possible you are having a wicking issue, do you generally do a 50/50 mix and they vape ok? Assuming 1.8/2.0 ohm (LR) at 3.2v is 5.69/5.12wats respectively well with in the green range. At 3.7v the wattage are 7.61/6.85 towards the high side of green. I'm leaning towards wicking or possibly sugars. I have choc. mint (Grasshopper) from HHV but it's a 70/30 and not having any issues at the wattage you are using, maybe try thinning it a little :unsure:
 
Last edited:

ridethespiral

Super Member
ECF Veteran
Verified Member
Jan 7, 2013
323
111
Edmonton AB, Canada
I did try thinning it out. Added 3 drops of water to about 7ml of juice. I received another 6 flavours on 50/50 and even some 100% by and the chocolate mint is the only one that does this.

I'm put it in my vivi nova mini with a 2.4 ohm head and at 3.2v it seems to not be burning but the flavor is rather muted and lacking.too scared to turn it up lol. The supplier I got it from suggested I cut the rubber piece a tiny bit to allow more juice to enter the head. Going to try that aster I get home from work.

Sent from my SGH-I717D using Tapatalk 2
 

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
A 2.4ohm at 3.2v is a real cool vape, wouldn't do it for me either at that wattage. I haven't used the vivi nova yet and haven't gone thicker than a 70/30 mix. I generally vape at around 6.5watts when using a tank/clearo that relies on wicking, depending on how it feeds. Hope you get it worked out :)
 
Status
Not open for further replies.

Users who are viewing this thread