Cleaning out Cartridges

Status
Not open for further replies.

Dana A

Ultra Member
ECF Veteran
Verified Member
Feb 25, 2012
2,778
1,292
48
Iowa
Get a turkey baster (bulb style) and pull off the bulb then put the carto inside thread side down. Then replace the bulb. Then start drawing boiling water into the baster and when you squirt it back out it will run threw the carto cleaning it. Then keep squirting air threw to get excess water out at the end. Then I bake my cartos in the oven at 275 for about an hour. Take em out of the oven and let them sit overnight. If this doesn't get em clean and dry nothing will. Good luck
 

Ken62

Super Member
ECF Veteran
Verified Member
Dec 23, 2012
703
765
Weatherford, Texas
Get a turkey baster (bulb style) and pull off the bulb then put the carto inside thread side down. Then replace the bulb. Then start drawing boiling water into the baster and when you squirt it back out it will run threw the carto cleaning it. Then keep squirting air threw to get excess water out at the end. Then I bake my cartos in the oven at 275 for about an hour. Take em out of the oven and let them sit overnight. If this doesn't get em clean and dry nothing will. Good luck

love love love the baster idea!!! I find that 2 15 minute boils doesn't get them completely clean. I don't dry them out past blowing and spinning them dry, when no more water comes out I fill and enjoy :) Haven't had a problem with that.
 

Ken62

Super Member
ECF Veteran
Verified Member
Dec 23, 2012
703
765
Weatherford, Texas
I was told a few hours in vodka 2 cycles, boil and then dry will work.

What do you do with the vodka once you are done with it?

drunk-smiley-emoticon.jpg
 

SpEcTReCHieF

Ultra Member
ECF Veteran
Verified Member
Oct 19, 2010
1,548
1,217
Florida
I've always soaked mine in ever clear and then flushed them with hot water and allowed them to dry for a day or two

I do the same, Everclear soak and rinse with a dropper, then dropped into boiling water for about 5 minutes, then blow them out and let dry.

But Sweetspot if you are talking cartridge vs a cartomizer, just rinse them out with warm water. You can remove the foam, rinse in warm water and reinsert it also. Ensure you blot it dry with a paper towel or something first. Hope that helps
 

SweetSpot

Full Member
Jan 5, 2013
42
25
35
Ohio
Are you asking about cartridges or cartomizers? (2 piece or 3 piece e-cig)
For a cartridge just pull the small piece of foam out and rince it in hot water. With a cartomizer ......... sorry but menthol is one of the flavors that you will never get completly out of them, even with the boil 5 times method.

I have cartridges and I used the rinse out method, though I didn't take the foam out, just blew through it to get the water out and it worked just fine. Thank you so much.
 
Status
Not open for further replies.

Users who are viewing this thread