Cleaning RDA for different juices

Status
Not open for further replies.

JD1

Vaping Master
ECF Veteran
Nov 20, 2010
4,180
2,644
KY
^^^ If you want it bone dry, but I always just patted it dry as best I could with a tissue, then pulse fired the coil a few times, loaded up juice and started vaping. First few pulls would be a little weak but performance and taste came back fairly quick.

Edit: I'd say with silica, after some pulse fires, saturate the wick with juice and vape it off before filling the tank.
 
Last edited:

djezewski

Vaping Master
ECF Veteran
Verified Member
May 31, 2013
3,515
1,861
67
Wayland, New York, United States
What I ended up doing is took a syringe and squirted off the wick and coil with vodka, a quick rinse in tap water. Took a paper napkin and gently squeezed the wick, patted the coil. Rinsed the top tank and wiped out with napkin. Dry burned pulsing until coils looked clean. Put juice on coil and wick, filled a bit more around it. Put the top tank on waited about 10 minutes. I few week gentle inhales. It seems good to go. I have pistachio in there which it is a very weak tasting juice..and no menthol taste. I was quite surprised. I am so used to pc tanks that hold the menthol flavor.
 
Status
Not open for further replies.

Users who are viewing this thread