clearomizer tanks...HELP!!

Status
Not open for further replies.

oldbroad

don't need no dang title..I'm queen of the world!
ECF Veteran
Verified Member
Dec 5, 2009
12,088
84,845
Lower Mich.
I just received this clearomizer tank to day, took off the two caps, filled the tank to just below the inner white cap, using a syringe thru the little side hole., screwed it onto the battery, ( it was nice to see exactly how much juice I had in there)
Took a vape...nothing!But I saw the juice on the other side of the white cap ( where the center and side holes for filling are) ( on the same side as the tip)I also noticed that the red colored coil goes only halfway towards the thread end, as apposed th the blue one which goes all the way to the attie end.
Did I get a defective one?!:glare:
 

Tendril

Super Member
ECF Veteran
Jul 21, 2010
479
283
USA - Illinois
I also noticed that the red colored coil goes only halfway towards the thread end, as apposed th the blue one which goes all the way to the attie end.

On the clearomizer I use that's how it should be; the red wire is welded to the air tube/vertical shaft about halfway down its length and the other (blue/green) goes from the coil cup down all the way to the threaded end.

Using a multimeter you could test the resistance between the two connectors (the threads on the clearomizer and the air-tube protruding from it). Most clearomizers advertise their resistance (in ohms)
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread