Cloudy clearomizer?

[mylose64]

I've been using a clearomizer with cherry-cinnamon liquid.

It's stained the clearomizer a thick foggy yellow.

I'm debating if I should get a map tank, but I don't want it to do the same thing!

Is there a way to clean this? I was thinking boiling the clearomizer?

 

[Credo]

See this link: RoyalSmokers electronic cigarette factory in Shenzhen

A PH over 7 isn't good for them. Some juices just eat the PV sleeves to bits.so they recommend using the metal ones for such juices.

I had one do the same thing with a cinnamon flavor. I was able to cut off a 3ml syringe and replace the tube with that.

 

[Liv2Ski]

Cinnamon is an oil so if there is any natural cinnamon flavor that is a no no for that plastic. It will make it cloudy and in high enough concentrations the clear tube will actually start to fall apart. The MAP's are much thicker and will hold up to that flavor better

 

[mylose64]

Cinnamon is an oil so if there is any natural cinnamon flavor that is a no no for that plastic. It will make it cloudy and in high enough concentrations the clear tube will actually start to fall apart. The MAP's are much thicker and will hold up to that flavor better

will it still stain it?

 

[Liv2Ski]

will it still stain it?

Not sure but I have run mine with DIY Cinnamon Roll for about 5 weeks and it is crystal clear. The Lorann cin roll is artifical flavor though so no oil in it.

 

[mylose64]

is there a way to lower the PH?