Coil wattage recommendation issue

[supermanrs0226]

Ok so I am currently using the geekvape z series coils. I use a .4 coil but my issue is that the chart on geekvape's website has the listed recommended wattage at 50 to 60 watts. But the coils themselves say 60 to 70 watts. So now I am confused as to were I should set the wattage on my mod. Which range would yall go with the one on website or the one on the coils themselves?

 

[DavidOck]

Charts...

Start at some low value and work up until you're happy with the vape. With that setup, maybe start at 50 and go up in, say, 5 watt steps. Find what works for YOU, not some dang chart!

 

[supermanrs0226]

Yeah I have been vaping at the 55 to 60 watt range. And that is were I get the best flavor and cloud for me. But I just find the whole thing confusing because of the two ranges. But thank you for the advice. I am also get about a week out of a coil which is acceptable to me.

 

[DavidOck]

Sounds like you have it dialed in, then

Yeah, charts and graphs often do make a good starting point, but shouldn't be taken as any sort of final word.

 

[supermanrs0226]

Yeah I am quickly learning that. Might grab a pack of the .2 coils and try those out. Eventually I want to get an RTA. But for now the Zeus is getting the job done.

 

[Coyote628]

The coils I use in my Fireluke 2 are .20 ohm and I vape these at 55 to 57 watts, depending on the flavor I'm using.

 

[supermanrs0226]

Yeah I think that I am going to stick with the 55 to 60 watts that I have been vaping at. Because for me that range gives great flavor and cloud.