Confused with me ego

[marcuswf123321]

Hello,first time posting here!

Ive spent quite some time trying to figure out why my ego-N 650 mah is puttin out more flavor and vapor then my ego twist, no matter what voltage i set it at.

I'm shifting between a kanger protank mini v2 (re-wicked with cotton), an iclear 30, and a CE4 V2 clearomizer.

Could someone explain to me, or maybe my twist is just not working right?

 

[dragonbone]

Welcome to the forum Marcus.

Silly question, but is your Twist fully charged?

 

[fabricator4]

Hello,first time posting here!

Ive spent quite some time trying to figure out why my ego-N 650 mah is puttin out more flavor and vapor then my ego twist, no matter what voltage i set it at.

I'm shifting between a kanger protank mini v2 (re-wicked with cotton), an iclear 30, and a CE4 V2 clearomizer.

Could someone explain to me, or maybe my twist is just not working right?

Because the ego is fixed voltage, probably. You need to find out what that voltage is, and just set to the twist to that or very close to it. The tendancy with VV is to turn it up higher to get more vapour, however this can give muted flavour, or even introduce off flavours.

When you first give up smoking it's very hard to judge the correct voltage from flavour alone as your sense of taste is still ruined from smoking. As the weeks and months pass the sense of taste comes back and you will know very quickly when the voltage is too high.

Something that is hard to tell until this happens is that if you burn the juice on a coil, the flavour doesn't come good straight away when you turn it down. Sometimes a burnt coil just needs to be scrapped.

 

[mediocre toker]

Something that you may have over looked. Take off your tank/clearo/or whatever... Get a piece of toilet tissue and twist it into the firing pin of your spinner/twist. Does it come out wet? Now try your tank again and you'll have improved power to your tank.
It's worth doing this as part of your daily vape routine as if it's left a- kind-of siphoning of the juice in your tank could happen and empty your tank over your battery.YMMV

 

[Decimate]

i say keep using your original battery if it outperforms the one with variable voltage

 

[marcuswf123321]

Thank's for the quick reply's!
My twist is set for 3.8 atm. and i tried nearly every setting, in 0,1 volt increments (the best i can on a twist) and the vapor never seems to get as good as on the ego-n.
I tried cleaning the firing button and it helped a little, but it's still not the same.

 

[marcuswf123321]

i say keep using your original battery if it outperforms the one with variable voltage

Yeah, i do. But it really bothers me!

 

[Decimate]

Thank's for the quick reply's!
My twist is set for 3.8 atm. and i tried nearly every setting, in 0,1 volt increments (the best i can on a twist) and the vapor never seems to get as good as on the ego-n.
I tried cleaning the firing button and it helped a little, but it's still not the same.

Most egos fire at 3.3v, maybe try taking it down to that

 

[d42kn355]

Generally at full charge the fixed batteries run between 3.9 volts (at absolute max capacity) to 3.7 volts and keep dropping from there, if you keep your twist a little higher than this, you should produce the same amount of flavor as long as your contacts are clean on both the pin on the battery, as well as the threads, and the coil pin on your tanks (as well as their threads) Sometimes, depending on the model, you may have to take a pliers to lower the coil's pin to make a stronger connection with your battery, as some of them have a lower pin down in the 510 connector. I know that this was the case on MY protank mini v2. I was using someones VV and they have a super low pin, and at first my tank would not even fire, I grabbed a small needle nose and wiggled the pin down a little bit (from the gromet/insulator on the bottom of the coil) and it fired perfectly after that.
Hope this helps! (at least a little, lol)

 

[marcuswf123321]

Thanks!
I'll try that as soon as i can!

(And my twist are fully charged)

 

[d42kn355]

Not a problem ^_^ Hope it was helpful!

 

[danny4x4]

Could it be that the twist dial is kaput? I'm guessing that it's firing at a lower voltage than what's it's set to. Twisting the dial doesn't make any changes to the voltage. You would need a multimeter to check what voltage it's firing at.

 

[d42kn355]

That is a strong possibility too! Especially if it is one of those twist clones

 

[marcuswf123321]

Thank's for the answers, i think it's the deal. Cause nothing changes when i change the voltage.

 

[fleur_de_lis-in-FL]

You could use a multimeter to see if it is putting out what it is et to.

 

[Amraann]

Thank's for the answers, i think it's the deal. Cause nothing changes when i change the voltage.

I hope it is new enough to be under warranty? Maybe you can get it replaced?

 

[fabricator4]

Thank's for the answers, i think it's the deal. Cause nothing changes when i change the voltage.

In that case, it would appear to be faulty.

 

[Jflores86]

Sadly, it sounds as though you have a faulty clone. I have never had issues with authentic ego twists. In fact, they have lasted the longest out of all ego based ecigs for me personally.

 

[marcuswf123321]

Okay! I picked up an MVP today, and now i'm sure my twist's deal is broken..I don't think theres any warranty on it, so i have to live with that.

Thank's for the help!