Cotton qestion

[CallmeRage]

Hello, i have a dual coil setup on my igo l. I have one piece of cotton that loops and forms a U and goes through both coils. Should i cut it and have 2 seperate wicks? Thanks in advance

 

[Jscheiben]

I haven't tried running that type of wick and the only concern I have is that if one of the coils starts to choke the wick the other will run dry. The only way I do it is with 2 separate pieces of cotton with the ends tucked onto the deck of my RDA.

 

[itskohler]

Ive tried that and noticed the wick closest to the coil would dry out, but the U was soaked. That also depens on the size of your coils, resistance, and amount of cotton.

 

[NORCALEX]

I have always used two separate pieces of cotton, rolled them up pass them through the coil (unless its nano/micro) and then tuck the excess underneath/on the side of the coil to allow a nice amount of surface area of the coil to heat the cotton. I say give it a shot using two separate wicks and see how you like it compared to your current U set-up, preference is everything!

 

[CallmeRage]

Ive tried that and noticed the wick closest to the coil would dry out, but the U was soaked. That also depens on the size of your coils, resistance, and amount of cotton.

Ok thanks for the heads up, ill cut it and even it out

 

[itskohler]

Well if yours isn't having problems don't change it. Just if you notice what I did, you know the culprit.

 

[CallmeRage]

Well if yours isn't having problems don't change it. Just if you notice what I did, you know the culprit.

Well its not having problems but ill give it a go, might be better. I've got tons of boiled cotton so its no biggie. Thanks for the concern

 

[Tazwell]

I might try you way for my strong cinnamon juice. I only have one atty and have a hard time getting rid of the cinnamon flavor when I add new flavors to the same cotton.