Could anyone suggest a good juice well/drip well for a box mod?

[icemanx3]

Hi all!

My old goat mod came with a nice big drip well at the base of the atomizer. I find this essential as I am always over dripping, etc.

Can someone offer some suggestions of what I could use as a drip well for my madvapes 2xAA box mods? When I continue to build these, I am going to start adding a well.

Thanks so much!

ice

 

[icemanx3]

Crickets. Chirping. Lol.

ice

 

[lexi60]

How about somthing like this?
Stainless 37WC 3/8" finish washer cntrsink - 37WC - G&S Fastening Online Store
Home depo has these.
Drill it out to 11/32, Push battery connector through it.
I seen a post on this a while back. Just cant find it.
Hope this helps.

 

[asdaq]

Yeah a finishing washer is pretty good for this. A little bigger than the one in the link I think though. Size #10 comes to mind, I personally like a 15mm OD. Unfortunately you want to add it to the battery connector under the lip of the connector, so adding to a finished mod takes some doing. You may want to look into getting a 'drip shield' from an e-cig supplier to pop on after the fact.

Hah, just realized you are starting fresh... finishing washer all the way

 

[icemanx3]

Thanks to you both! So a finishing washer as shown in lexi60's link, but size 10 ish....this is precisely the info I was looking for.

AWESOME!

ice

 

[asdaq]

Did I mention they come in a lustrous brass finish too?