Could too many battery cycles/recharges be causing this problem I'm having?

Status
Not open for further replies.

betterthanyou

Senior Member
ECF Veteran
Verified Member
May 10, 2013
225
53
38
southern california
Using Samsung ICR 18650 2600mah flat top batteries with my Evic. I have had the batteries for quite a while now and gone through a significant number of charge cycles. I am using an Ehpro kayfun 3.1 with my device. I am building 1.5ohm single microcoils with cotton wicks. I have been noticing that when I apply power and dry burn my coils it has been taking 1-2 seconds for them to begin glowing evenly from the center outwards. I am building the coils correctly and wicking properly. Along with this delay to get the coil glowing I notice a significant drop off in power to the coil/vapor production after about 8 seconds.
I am wondering two things:
1. Could my Evic be starting to malfunction?
or
2. Is it possible that I have gone through too many charging cycles with my battery that could be causing these issues?

Thanks

 
Status
Not open for further replies.

Users who are viewing this thread