I have had the kanger pro for 3 days and have noticed it starts to leak and gurgle when 25% is left in tank. I removed a single wick from my first head and messed that one up trying to rewire it and with it being so small and already cut it was hard to I tossed the wire and wick out and saved the atomizer head that screws into the base. I am using the 2nd head but with all wicks in.
I want to build a head that will not leak so I can drain the tank. I vape 33%vg liquid isnt think and isnt thick.
What are the best materials to use for this % vg and any certain ways to build it other than videos on youtube.
I understand to my knowledge that more wraps of wire creates higher resistance. Before messing up the other head I was able to build it into a 1.8 Ohm head with the factory one being 2.5 . I received 2- 2.5 heads. After first rebuild the wire didnt wrap neatly it was already to short to I tossed it. I see potential in these things just need to customize it a bit.
I want to build a head that will not leak so I can drain the tank. I vape 33%vg liquid isnt think and isnt thick.
What are the best materials to use for this % vg and any certain ways to build it other than videos on youtube.
I understand to my knowledge that more wraps of wire creates higher resistance. Before messing up the other head I was able to build it into a 1.8 Ohm head with the factory one being 2.5 . I received 2- 2.5 heads. After first rebuild the wire didnt wrap neatly it was already to short to I tossed it. I see potential in these things just need to customize it a bit.
