Cuboid 150W common problems

[Elias Peltonen]

Hi!
Anyone who owns a joyetech cuboid, have you experienced any problems with your device.
My cuboid has this problem where it gives 0,4V voltage when atomizer unplugged and not firing (measured with circuit-analyzer). I noticed the problem when my atomizer (smok tfv4) started to heat up way more than it had heated up before. I think it gives way more voltage than it should when firing.
Is there anything I can do or do I send it back to the vendor

 

[Douggro]

I have had no issues with my Cuboid. Did the firmware upgrade immediately on receiving it for the wattage bump and revised TCR capabilities. There's an entire thread over in the Temp Control section devoted to the Cuboid.
Have you checked your firmware version and/or run the latest firmware update on it yet?

 

[Elias Peltonen]

I have had no issues with my Cuboid. Did the firmware upgrade immediately on receiving it for the wattage bump and revised TCR capabilities. There's an entire thread over in the Temp Control section devoted to the Cuboid.
Have you checked your firmware version and/or run the latest firmware update on it yet?

I updated it to 3.1 when i bought it and worked fine. When the problem started I downgraded the device but it didn't help.

 

[Douggro]

If you're reading a voltage pulse with no atty connected, it may be the "pulse" of the mod polling the connection - you see PBusardo mention this on many of his reviews on mods. Don't recall seeing this in particular for the Cuboid though. If it's a constant 0.4V that never shuts off, you may have a defective mod.