Okay so I have my DCA on my Provari and it won't fire. I got it to fire once with the dca screwed all the way down which meant no air flow. Any tips on getting it to work?
- Status
only 2 things spring to mind if no vapor means "no connection"...do not over-tighten yr dca(i think u mean dct..dual coil tank)..try loosen(should be finger tight) if still no working..try lift the centre post of yr provari slightly up(using a tweezer to do it & be gentle..hope this help U get to vape on yr prize provari..regards mafig
Right on. But I did mean dca. I think the center post on the dca isn't making a connection with the provari. All my other mods I put my dca on runs fine. Thx Mafig
I could be mistaken on this but it's my understanding a Provari will not function with dual coil cartos (or, I would presume, atomizers either). Something about the protection circuit seeing this rapid drain as a short and shutting down. Hopefully a Provari enthusiast will be along shortly to help you out. Happy Vaping!
If you are getting an error code on your display then its because the resistance is too low and the provari thinks its a short. Try dropping the voltage to 3.7 and see if it resolves it.
It could also be a tolerance issue with the threading on the dc. I find having a couple of adaptors in my kit box is a good idea.
I need to use a 510/510 adaptor on my provari with a lil mama tank if I pop certain cartomisers in because they are slightly shorter and cause the tank bottom to mate with drip collector and prevent airflow.
It could also be a tolerance issue with the threading on the dc. I find having a couple of adaptors in my kit box is a good idea.
I need to use a 510/510 adaptor on my provari with a lil mama tank if I pop certain cartomisers in because they are slightly shorter and cause the tank bottom to mate with drip collector and prevent airflow.
Last edited:
(BTW in the unsurprising event that I am mistaken and DCA here is not intended to stand for "dual coil atomizer", I must beg your pardon. I confess to knowing next to nothing about the Provari, and very little about much else except my E-Power.)
Cheers!
Cheers!
I think what the OP meant was DCA by Good Sense Vapor 
anyway, try to clean the connection inside where you screw the atty. if it still won't fire, I think the outside pin of the DCA doesn't connect to your Provari.. See if using a 510-510 adapter will fix the issue.. If so, try to buy the o-ring kit from GSV.. Hope this helps.
anyway, try to clean the connection inside where you screw the atty. if it still won't fire, I think the outside pin of the DCA doesn't connect to your Provari.. See if using a 510-510 adapter will fix the issue.. If so, try to buy the o-ring kit from GSV.. Hope this helps.Right on Six2arms. I'll give that a shot. Good thing I ordered an extra set of the pin and ORings.
Btw my provari isn't throwing codes or recognizing that there is an atty on it. That's the problem I'm having. Thx for the input guys.
- Status
Similar threads
