Cant seem to find the video showing how to set up the AFS. Is there a diagram showing what goes where?
Diagram or Video
- Thread starter HokieSmokie
- Start date
- th_trl_thread_readers 0
- Status
I made the mistake of taking it apart because I couldn't figure out where the juice Goes. 
When I Put A together I have One end piece left over and I don't know where it goes. Also I am not sure I put the rubber rings on the correct place because I am leaking !!
When I Put A together I have One end piece left over and I don't know where it goes. Also I am not sure I put the rubber rings on the correct place because I am leaking !!
Now I have all parts together but don't know where the rubber goes. It's times like this when a cigarette would help you think better.
I made the mistake of taking it apart because I couldn't figure out where the juice Goes.
no worries hokie.
AFS has 5 parts and 2 o-rings.
the first part is the tube. the other 2 parts are the 2 caps with internal (female) threads (they are like buckets) and 2 caps with external (male) threads.
screw the first female cap on the tube and the second female cap on the other side of the tube.
Now put the o-ring inside the female cap and screw the male cap on it.
Then put the 2nd o-ring inside to the 2nd female cap and screw the 2nd male cap on it.
Unscrew one of the female caps. The male will come out together with it.
Put a catridge to the atomizer and push the catridge through the cap that is still attached on the main tube, until the atomizer's threads comes to the same level to the cap.
Pull out the catridge. Take care the atomizer to not come out of the tube when you pull out the catridge.
Fill the tube with liquid.
Try to screw the pair of caps. The atomizer has to go inside the little hole of the cap but not inside the o-ring.
You will see that atomizer is moving down while you screw the pair of caps.
Then put AFS with atomizer on the GG and smoke
I might have it .. with the exception of the rubber rings. I am going to take it apart and start from scratch. When filling it .. If you put juice directly into the atty, wouldn't it leak into the tube where it belongs ? Or do you need to take it apart to fill it.
You will not put liquid inside the atty, only inside the tube Hokie.
I must be doing some thing wrong .. I put it together just as you said and then took on side [male and female] off together. I can't get the atty to go through the hole no matter which end I remove. Even if I take the cart off the atty. ... It's one of the Totally Wicked attys ..
You will leave the cart on the atty and you will push the cart inside the hole of the caps that are attached to the tube. You have to put a little more strength because o-ring is tight
Have a look at these videos to show you how to do this .... You will need to turn up your volume quite a bit to hear the sound.
YouTube - AFS 1
YouTube - AFS 2
YouTube - AFS 3
YouTube - changing the AFS atomizer
Hope this helps.
YouTube - AFS 1
YouTube - AFS 2
YouTube - AFS 3
YouTube - changing the AFS atomizer
Hope this helps.
Very good video but maybe this AFS is not for me. Put it together just like you said .. PUSHED HARD and got the atty through the barrel .. added some juice and it just wouldn't vape .. As if the cart wasn't letting vapor to pass through it .. The atty was working fine but later it seemed my batteries were dead. Too late to play now .. maybe tomorrow .. or not ..
Its easy Hokie, you just did have time to play with it. When you put liquid inside the tank then you keep the laser hole facing the floor and keep the GG parallel to the floor.
You know where the laser hole is because its on the same line with the atomizer's hole.
Keep in mind that you have to put inside the atomizer a catridge that is short so you dont block the laser hole, so if you use the RN4075 catridge you have to remove the brown extension that it has
When you will get used to it you will not be able to smoke by dripping. AFS is the solution for all dripping problems.
Imeo
Another situation where instruction sent with the AFS would have be in order.
I agree Harpo. I will do it for sure next time. I will make instructions and then I will give to Lisa to make it better
I agree Harpo. I will do it for sure next time. I will make instructions and then I will give to Lisa to make it better
That's great. Thankss.
I will try it again tonight. I better practice with some old bottle of juice that I do NOT like so I don't waste all the YUMMY cappuccino and chocolate mint that I smoke regularly .. When I gave up last night I was a sticky - yucky - mess from spilling juice everywhere .
I wanted to post that you can make experiments with water first but it will rust the atty so if you have liquid that you dont like it then use it, its a very nice idea.
I agree Harpo. I will do it for sure next time. I will make instructions and then I will give to Lisa to make it better
I already designed and had an instruction card professionally printed that I supplied with every AFS I sold. You've seen it, Imeo, you must have forgotten.
AFS Instructions
Last edited:
I already designed and had an instruction card professionally printed that I supplied with every AFS I sold. You've seen it, Imeo, you must have forgotten.
Lisa that's great. Hopefully in the future all AFS purchases will be accompanied by one.
- Status
Similar threads
