I got in some new juice and was priming the atty and put too much in and it leaked into auto battery. It still lights up when i screw it on or move it but not when I draw on it. Any way to remedy it or just gonna have to get a new battery.
Did I ruin my battery?
- Thread starter jaded
- Start date
- th_trl_thread_readers 0
- Status
Most likey it won't work right again. You might be able to blow into it and get it to work some, but this is a problem that is hard to fix. You might want to look into getting some manual batteries that don't have the hole in them. Then you don't have to worry about this happening anymore.
I might have to look into the manuals, I had been doing find with the autos and prefer them cause i like to keep them in my mouth like a black and mild but I was going through menthol withdrawls and got a little overexcited when my crystals finally got here.
Thanks for the feed back, I will try blowing it out..
On a positive note Turkish Blend + menthol=pretty good
Thanks for the feed back, I will try blowing it out..
On a positive note Turkish Blend + menthol=pretty good
Try sitting it on the battery connector end on some paper towel overnight - might help though probably not since most auto switches tend to use a foam cushion and that loves to drink juice.
Well im not sure what did it, but its working today. I blew it out, used some alcohol to clean the connection, and heated it a little with a blow dryer not of that worked, but juat leaving it alone over night seemed to work. I guess I just got lucky, but thanks for the ideas.
- Status
